The product assortment on this website may differ from what is available where you are located. Do you want to visit the American website instead?

LDK19501/10

Duct Shaper

For Microducts ID 2-10 mm

  • Makes oval microduct cuts round in seconds
  • Minimizes installation stops in connector interfaces
  • For microducts ID 2-10 mm

The tool is used to make the duct end perfectly round before mounting of microduct connectors.

A round microduct end will minimize the risk of fibers or cables get stuck in the connector.

Cut your microduct with a microduct cutter, insert the tip of this tool into the end until it stops and twist it a couple of times to regain the shape of the duct again.