A selection of Thick Wall Duct Assemblies with a combination of 7/3.5mm and 14/10mm ducts.

5/MPB30326+AU

Microduct Assembly 7/3.5 + 14/10mm

TWD 7/3.5 + 14/10mm 6-25 way TIA598 Termite Protected

For direct burial
6, 10, 14, 19, 22 or 25 bundled ducts
7/3.5 mm and 14/10 mm microducts
Low friction inner surface
Longitudinal grooves for maximum installation lengths in 14/10 mm ducts
Nylon sheathed microducts for termite protection
Optional integrated tracer wire

For direct burial
6, 10, 14, 19, 22 or 25 bundled ducts
7/3.5 mm and 14/10 mm microducts
Low friction inner surface
Longitudinal grooves for maximum installation lengths in 14/10 mm ducts
Nylon sheathed microducts for termite protection
Optional integrated tracer wire

The tight protected duct assemblies consist of a number of microducts with an inner low friction, antistatic surface that enables installation of micro cables, nano cables or air blown fibers. The thick inner wall of the microducts allow for installation directly into the ground without the need for additional protection. The nylon layer applied to each microduct makes these assemblies suited to termite prone areas even where the outer jacket is removed. Where optioned, the integrated tracer wire saves time and installation cost since an additional wire for tracing is not required.

The duct assemblies are available in several configurations from 6 to 25 microducts.

Both the 14/10 mm and 7/3.5 mm microducts are suitable for installation of air blown fibers or nano cables and the 1/10 mm microduct can also be used for blowing micro cables. The microducts have a low-friction inner surface for best blowing performance.

Microduct Assembly 7/3.5 + 14/10mm - Technical Details

Microducts: HDPE and Nylon
Outer sheath: HDPE
Tracer wire: 24 AWG Tinned Copper (optional)

Technical Information

Product Color	White
Color Code	TIA598
Temperature, Operation [°C]	-40 to +60
Temperature, Storage [°C]	-40 to +60
Temperature, Installation [°C]	-20 to +50
Conformance	Abrasion: IEC 60794-1-2-E2B(1) Kink: IEC 60794-1-2-E10, 20 x outer diameter Impact: IEC 60794-1-2-E4 Crush: IEC 60794-1-2-E3 Tensile: IEC 60794-1-2-E Bend: IEC 60794-1-2-E11A Torsion: IEC 60794-1-2-E Flexibility: IEC 60794-1-2-E8 Inner Clearance: IEC 60794-5-20, IEC 60794-5-10, Ann. D
Marking	Duct assemblies have markings showing the tube length. The individual microducts are indentified by their colours according to the TIA standard. Bundles of more than 12 ducts are also identified by numbers 1 and 2. The assemblies come with a white outer sheath, or with a customised outer sheath colour by special order.