Marker Peg/End Stop

The marker peg is used to find microduct ends, splices, cable coils or other network elements that needs to be easily found.

The marker peg is normally installed horisontally into the ground and attached to a microduct end with the enclosed rubber adapters. The marker peg can also be used both vertically or horizontally as a stand-alone product for OEM built in applications. A general purpose version without duct adapters is therefore also available.

Detection is carried out with standard frequency of 101,4 kHz.

The marker peg consist of a hard plastic case. Inside the case, a reflector coils is mounted that reflects RF signals of 101,4 kHz. The reflector coil is sealed by the outer case and a silicone filling compound. The peg is normally used togehter with rubber adapters to double as a duct end cap. It can also be mounted in closures or in manholes.

The rubber adapters are designed so that they can be cut to fit the ducts. Suitable for ducts with 7, 8, 10, 12, 14 and 16 mm outer diameter.