- Products
- Accessories for Cables and Ducts
- Warning Nets and Locators
- Marker Peg/End Stop Push-Fit
MPB32060+
Marker Peg/End Stop Push-Fit
Horizontal Push-Fit Marker Peg for detection of Duct Ends
- Horizontal RF marker for direct buried installation
- Push-fit for fast installation
- Doubles as a microduct end cap
- Can be pressurized for duct integrity test upto 15 Bar
- Standard telecom frequency 101.4 kHz
- Detection range up to 2m; horizontal 1m; vertikal 1,5- 2m
- Available for 7mm duct
- Horizontal RF marker for direct buried installation
- Push-fit for fast installation
- Doubles as a microduct end cap
- Can be pressurized for duct integrity test upto 15 Bar
- Standard telecom frequency 101.4 kHz
- Detection range up to 2m; horizontal 1m; vertikal 1,5- 2m
- Available for 7mm duct
The marker peg is used to find microduct ends, splices, cable coils or other network elements that needs to be easily found.
The marker peg is normally installed horizontally into the ground and attached to a microduct end with the enclosed rubber adapters.
The marker is equiped with a push-fit connector which makes it quick and easy to connect the end of a 7 mm microduct to the marker in just seconds.
The marker peg is used to find microduct ends, splices, cable coils or other network elements that needs to be easily found.
The marker peg is installed horisontally into the ground and attached to a microduct end.
The marker is equiped with a push-fit connector which makes it quick and easy to connect the end of a 7 mm microduct to the marker in just seconds.
The marker is blocked and withstands air-pressure up to 15 Bar which enables it to be used also for duct integrity test.
Detection is carried out with standard frequency of 101.4 kHz.
The marker peg consist of a hard plastic case with a push-fit connector. Inside the case, a reflector coil is mounted that reflects RF signals of 101.4 kHz. The reflector coil is sealed by the outer case and a silicone filling compound.
Suitable for ducts with 7 mm outer diameter.
All materials are RoHS and REACH compliant
Technical Information
Tuotteen väri | Orange |
---|---|
Lämpötila, käyttö [°C] | -20 to +50 |
Lämpötila, varastointi [°C] | -40 to +60 |
Lämpötila, asennus [°C] | -20 to +50 |
Vaatimustenmukaisuus | RoHS REACH |
Tekniset tiedot | Detection Frequency: 101.4 kHz Range: Horizontal 0.6-1m; vertikal 1.5- 2m Pressure tightness: 10 bar |
Tilaustiedot | Delivered in packs of 10 pcs. |