Marker peg with push fit connection to duct

MPB32060+

Marker Peg/End Stop Push-Fit

Horizontal Push-Fit Marker Peg for detection of Duct Ends

Horizontal RF marker for direct buried installation
Push-fit for fast installation
Doubles as a microduct end cap
Can be pressurized for duct integrity test upto 10 Bar
Standard telecom frequency 101.4 kHz
Detection range up to 2m; horizontal 1m; vertikal 1,5- 2m
Available for 7mm duct

Horizontal RF marker for direct buried installation
Push-fit for fast installation
Doubles as a microduct end cap
Can be pressurized for duct integrity test upto 10 Bar
Standard telecom frequency 101.4 kHz
Detection range up to 2m; horizontal 1m; vertikal 1,5- 2m
Available for 7mm duct

The marker peg is used to find microduct ends, splices, cable coils or other network elements that needs to be easily found.

The marker peg is installed horizontally into the ground and attached to a microduct end.

The marker is equiped with a push-fit connector which makes it quick and easy to connect the end of a 7 mm microduct to the marker in just seconds.

The marker is blocked and withstands air-pressure upto 10 Bar which enables it to be used also for duct integrity test.

Detection is carried out with standard frequency of 101.4 kHz.

The marker peg consist of a hard plastic case with a push-fit connector. Inside the case, a reflector coil is mounted that reflects RF signals of 101.4 kHz. The reflector coil is sealed by the outer case and a silicone filling compound.

Suitable for ducts with 7 mm outer diameter.

All materials are RoHS and REACH compliant

Technical Information

Product Color	Orange
Temperature, Operation [°C]	-20 to +50
Temperature, Storage [°C]	-40 to +60
Temperature, Installation [°C]	-20 to +50
Conformance	RoHS REACH
Technical Notes	Detection Frequency: 101.4 kHz Range: Horizontal 0.6-1m; vertikal 1.5- 2m Pressure tightness: 10 bar
Ordering Information	Delivered in packs of 10 pcs.