- Products
- Microducts and Microduct Assemblies
- Direct Buried Thick Walled Ducts
- Primary Microduct 7/3.5 mm
MPB30317+
Primary Microduct 7/3.5 mm
TWD 7/3.5 mm Single Way Termite Protected
- For direct burial
- 7/3.5 mm microducts
- Low friction inner surface
- Suits branching, lead ins and runs through existing duct
- Nylon sheathed for termite protection
- For direct burial
- 7/3.5 mm microducts
- Low friction inner surface
- Suits branching, lead ins and runs through existing duct
- Nylon sheathed for termite protection
The thick walled microduct are designed with an inner low friction surface that enables installation of air-blown fiber units or nano cables. The thick wall of the microducts allow for installation directly into the ground without the need for additional protection. The nylon layer applied to each microduct makes these assemblies suited to termite prone areas. Single way microducts are suitable for branching and lead in connections in FTTH networks and can be used as a feeder from existing duct networks.
7/3.5 microducts are optimized for installation of air-blown fibers and nano cables. The microducts have a solid low-friction innner surface for best blowing performance.
Microducts: HDPE and Nylon
Technical Information
Temperature, Operation [°C] | -40 to +60 |
---|---|
Temperature, Storage [°C] | -40 to +60 |
Temperature, Installation [°C] | -20 to +50 |
Conformance |
Abrasion: IEC 60794-1-2-E2B(1)
|
Marking | Microducts are marked in a contrasting inkjet colour and are separately identified by their colour. 12 different colors are available: blue, orange, green, brown, grey, white, red, black, yellow, violet, rose and turquoise/aqua. Custom colours are available by request but minimum order quantities may apply. |