A selection of Thick Wall Ducts with TIA colours and a white jacket

5/MPB30322+AU

Microduct Assembly 7/3.5 mm

TWD 7/3.5 mm 1-24 way TIA598 Termite Protected

For direct burial
1, 4, 7, 12, 19 or 24 bundled ducts
7/3.5 mm microducts
Low friction inner surface for maximum installation lengths
Nylon sheathed microducts for termite protection
Optional integrated tracer wire

For direct burial
1, 4, 7, 12, 19 or 24 bundled ducts
7/3.5 mm microducts
Low friction inner surface for maximum installation lengths
Nylon sheathed microducts for termite protection
Optional integrated tracer wire

The thick walled microduct bundles consist of a number of microducts with an inner low friction surface that enables installation of air-blown fiber units or nano cables. The thick inner wall of the microducts allow for installation directly into the ground without the need for additional protection. The nylon layer applied to each microduct makes these assemblies suited to termite prone areas even where the outer jacket is removed. Where optioned, the integrated tracer wire saves time and installation cost since an additional wire for tracing is not required.

The duct assemblies are available in several configurations from 1 to 24 microducts.

7/3.5 mm microducts are optimized for installation of air-blown fibers and nano cables. The microducts have a solid low-friction innner surface for best blowing performance.

Microduct Assembly 7/3.5 mm - Technical Details

Microducts: HDPE and Nylon
Outer sheath: HDPE
Tracer wire: 24 AWG Tinned Copper (optional)

Technical Information

Product Color	White
Color Code	TIA598
Temperature, Operation [°C]	-40 to +60
Temperature, Storage [°C]	-40 to +60
Temperature, Installation [°C]	-20 to +50
Conformance	Abrasion: IEC 60794-1-2-E2B(1) Kink: IEC 60794-1-2-E10, 20 x outer diameter Impact: IEC 60794-1-2-E4 Crush: IEC 60794-1-2-E3 Tensile: IEC 60794-1-2-E Bend: IEC 60794-1-2-E11A Torsion: IEC 60794-1-2-E Flexibility: IEC 60794-1-2-E8 Inner Clearance: IEC 60794-5-20, IEC 60794-5-10, Ann. D
Marking	Duct assemblies have markings showing the tube length. The individual microducts are indentified by their colours according to the TIA standard. Bundles of more than 12 ducts are also identified by numbers 1 and 2. The assemblies come with a white outer sheath, or with a customised outer sheath colour by special order.