- Products
- Accessories for Cables and Ducts
- Duct Connectors and End Plugs
- Microduct Connectors and End Stops
MPB30601+
Microduct Connectors and End Stops
For 3-20 mm Microducts
- Easy “push-in” installation
- For above ground use or direct buried use with external cover
- Case locks the connector to prevent accidental removal of duct
- For 3 to 20 mm microducts
- Easy “push-in” installation
- For above ground use or direct buried use with external cover
- Case locks the connector to prevent accidental removal of duct
- For 3 to 20 mm microducts
The connectors and end caps for microducts provide a quick, easy and secure connection or water sealing of microducts.
The product comes in three different versions:
- Straight Connectors are used to join sections of microducts
- Reduction Connectors are used to join microducts of different dimensions
- End Stops are used to block open duct ends and prevent water and dirt from entering the microduct
For installation directly into the ground, use versions with external cover.
The connectors are tested for best functionality in combination with the Hexatronic air blown fibers, nano cables and micro cables.
The design of the connector incorporates pressure tight seals with O-rings and internal steel teeth that prevents accidental separation of the connector from the microduct once installed.
Removal of the duct is achieved by pushing the green collet inwards.
To increase crush resistance when installed direct buried, an external plastic cover is used. The cover prevent the accidental release of collets during installation and provide protection and impact resistance in use.
Body: Clear PC
Collet: POM
Grip Ring: Stainless Steel
O-Ring: Nitrile Rubber
Cover: PP
Technical Information
Product Color |
Body: Clear
|
---|---|
Temperature, Operation [°C] | -40 to +65 |
IP Rating | IP68 |
Conformance | Microduct Bending: EN 50411-2-8, -15/+45 °C, +/-30° - Pass Crush Resistance: EN 50411-2-8, -15/+45 °C - 450 N710 min - Pass Impact Resistance: EN 50411-2-8, -15/+45 °C - 450 N710 min - Pass Insertion Force: EN 50411-2-8, 50/120 N - Pass Tightness: DTAG B.2.4.3.1, 15 bar/1h, p< 10 % - Pass Microduct Retention: DTAG B.2.4.3.2, 238/685 N Burst: DTAG B.2.4.3.3, min 30 bar - Pass Spade test: DTAG B.2.4.3.4 - Pass Tests performed on tyical samples of 7 mm and 16 mm connectors. |
Installation Notes |
Working Pressure: <15 bar
|
Ordering Information | The articles are ordered in individual pieces, but delivered in packs with defined quantities. See pack size in the article list below. |